U-PROX UPROX-BXS-R Dual PIR detector for outdoor side vision

U-PROX UPROX-BXS-R. Dual PIR detector for outdoor side vision. Incorporates transmitter via radio UPROX-049 (U-Prox Wireport). Coverage of 12m on each side. Can be connected to a CCTV camera for sending visual alarms. 4 detection zones (2 on each side). Adjustable detection range and sensitivity. Independent alarm outputs. Tamper tamper. IP55. Self-powered with lithium or alkaline batteries 3V~9V DC or from transmitter via radio. Uprox-049 + optex-118.

• Dual side-view dual PIR detector for outdoor use.
• Built-in 868MHz radio transmitter UPROX-049 (U-Prox Wireport)
• Side view with dual sensor on each side
• Can be connected to a CCTV camera to send a visual alarm when an intruder is detected
• 4 PIR technology: detection range, sensitivity and alarm output can be set independently on each side
• 12 meters coverage on each side
• Adjustable angle to the wall at 0° or 3°.
• 2 detection zones on each side
• Detection range adjustable in 5 levels (2.5/3.5/6/8.5/12 meters)
• Mounting height of 0.8 ~ 1.2 meters
• Adjustable sensitivity on each side (extremely high and normal)
• SMDA (Super Multi-Dimension Analysis) processing logic against false alarms from vegetation and adverse weather factors
• Quick closing of the front cover and automatic walk test (3 minutes duration) when closing the cover
• Alarm relay right side: NC/NA (10V DC, 0.01A, single, right or general)
• Alarm relay left side: NC/NA (10V DC, 0.01A, individual, left or general)
• Fault/tamper output: NC/NA (10V DC, 0.01A)
• Built-in rear tamper
• Double conductive mesh protection
• Built-in level for fast and accurate installation
• Easy visual identification of all setting elements (marked in blue on the detector)
• Quick opening by 90-degree turn of lower screw
• Includes protected enclosure at the rear to house the radio transmitter
• IP55 degree of protection
• Operating temperature range -30°C ~ +60°C
• Powered by 3V~9V DC lithium or alkaline batteries (not supplied)
• Compatible batteries: CR123A x3, 1/2AA x3 or x6, CR2 x3
• Battery holder: OPTEX-42 (RBB-01)
• It is recommended to power from the transmitter battery via the radio transmitter used.
• Maximum consumption: 8mA
• Dimensions: 199.7 x 92.8 x 98.7 mm (199.7 x 92.8 x 98.7 mm)
• Weight: 550 g