Low gain mast amplifier (LTE700) 2 inputs: BIII/DAB/UHF-UHF Televes

Low Gain Mast Amplifier

2 inputs: BIII/DAB/UHF-UHF

Mast installation amplifier to amplify terrestrial television signals from various antennas.

It consists of 2 inputs with amplification in all bands. The amplifier is powered at 12Vdc through the output coaxial cable.

NETWORK compliant.

Highlights

• Separate amplification of each band
• EasyF connection system
• Fully automated manufacturing and subjected to rigorous quality controls
• High armored chassis, made of Zamak

Characteristic

• LTE/5G filter to eliminate telephony interference
• ON/OFF switches to allow DC to pass through the UHF inputs, to power a BOSS system
• simple assembly. Flange for fixing to the mast included
• Orange casing made of resistant orange ABS plastic for outdoor installation

EasyF connection system: simplicity and savings

The EasyF is an innovative connection concept for the internal conductor of the coaxial cable (live), which is inserted directly into the device, increasing the reliability of the connection. In addition, thanks to the absence of "F" connectors, it is possible to reduce the chassis and secure the connection of two cables with a single screw.

• Real saving of time: speeding up the installation is possible, since it is not necessary to carry out the connectorization of the coaxial cables. In addition, the process of screwing the connectors into the device is avoided, which is sometimes complicated when space is not enough.
• Connection reliability: the tie that holds the cables prevents the coax from coming loose
• Economic savings: no additional connector (neither "F" nor "CEI") is needed
• Space optimization: inputs and outputs are always located on the same side of the device, avoiding bending coaxial cables and facilitating work inside cabinets and registers
• Very easy assembly in three steps: it is only necessary to screw and unscrew the covers to connect two cables:

1. Unscrew the cover of the device to access the connection

2. Insert the previously stripped coaxial cables

3. Close the lid and screw to secure the connection

Find out more about the reliability of the EasyF system

With EasyF, the connection of the coaxial cable to the device is carried out by means of an automated system of insertion of the live (internal conductor) by contact, without requiring soldering.

• Like the first day: the lifetime of the device increases by eliminating the possible deterioration of the welds over time
• Reduction of the rate of failures: generally produced by cold welds
• Optimization of electromagnetic behavior: at high frequencies
• Reinforcement of our commitment to the environment: pollution caused by the welding process is eliminated and electricity consumption in production is reduced

application example