Upper section with rim 2.5m turret series 180 SE RPR Televes

This product is not sent to some countries or areas, if the cart does not have available carriers, you can contact us here

Upper section constructed in steel, to which a "zincado brillante + bichromate" base treatment is applied, they are used in two types of finishes (RPR or polyester paint). They currently allow installation at heights from 1 to 50.5 m.

Depending on the model, they implement threaded or plug-in fittings (SE finish) for their union.

The series 180SE, allows to cover the most basic needs of catchment with its recessed sections. The maximum height is 7.5 m, including 3m mast. 

Installation types (Mod. 180 y 360)

Section by section

Fixing the lower section to the base in the proper vertical position, and then mounting the consecutive intermediate sections, which will be fixed with the corresponding guy-wire; the assembly is carried out by climbing the already placed sections and raising subsequently the section to be placed, using for it the adequate elevating tools.
The climbing has to be made with the appropiate safety conditions (safety-belt, anchoring, etc.); there won’t be more than two sections without shoring up. In case of coinciding two sections without guy-wire, auxiliary guy-wire will be used for the bracing of the sections during the set-up. The tower will be balanced adjusting the tension of the guy-wire and the using of proper balance-appliances.

Complete tower

First assembling the tower over the ground and raising it, once mounted, by means of a crane. This system can be used only with towers of heights lower than
18 meters in the model 180 and heights lower than 26 meters in the model 360.

Safety

If the installation of the tower is made on the roof, flat roof or other place of a building, the installer will take the necessary measures according to the indications of the architect responsible of the building, in order to know the mechanical resistance of these zones.

Specifications