Fermax 3254 DUOX PLUS PROGRAMMER

The DUOX installation programmer is a device, aimed at technical services and installers, which allows the status of a DUOX installation to be verified.

It has 2 operating modes:

CONSOLE MODE

Allows the programming and verification of the status of the programming of the DUOX system devices, either in the installation itself in operation or on the workbench.

In this case, it is necessary to supply the DUOX programmer with power through the built-in USB port.

INSTALLATION ANALYZER MODE

It allows the analysis of incidents (analysis of commands, data frames and their voltage levels) and verification of components in a certain installation, already underway.

It is fed, in this case, from the installation itself.

DUOX system: it is the first completely digital system in non-polarized two-wire technology. It is the most technologically advanced system in the world, which allows quick installation with just two wires. The most simplified and advanced installation system on the market. It maximizes the capabilities of intercom systems thanks to digital audio transmission, being capable of managing two simultaneous conversation channels.

DUOX offers the maximum simplicity of installation that enables the transmission of all signals: power, audio and data with maximum capacities.

Allows you to manage:

From 1 to 999999 homes:

Calls from Pushbutton Panel: 99

Calls from the Keyboard Panel:

Sub-Block: 99.

Block: 9999.

General Ticket: 999999.

From 1 to 10 plates:

Number plates:

General Tickets: 10.

Block: 10.

Sub-Block: 10.

Maximum distance from the first access to the last home: 300 m.

With DUOX you have maximum versatility, thanks to the stability and robustness in the signal transmission of this completely digital system that avoids any possible reflection and interference in the installation.

The DUOX amplifier includes a voice synthesizer as standard. When the lock release is activated, a message is emitted: "door open, close after entering".

Up to 3 telephones can be installed in each home.

Residential terminals require a simple programming that is done from the street panel. By means of this programming, a call code is assigned to each terminal (telephone).

The communication is private.

Cabling:

Any type of cable can be selected: parallel, twisted pair and UTP CAT5 in new works, and it is even possible to use existing wiring in replacement works (5 wires, 2-wire bell or old 4+N cable).

2 wires without polarity.

It is recommended to see the table of sections-distances-terminals-feeding.

Maximum distance from the first access to the last home: 300 m.

Technical specifications