Fermax 9443 DUOX PLUS ELEVATOR CONTROL UNIT

The DUOX PLUS Elevator Control Unit is a module used to provide elevator control service to the DUOX PLUS installation, that is, visitors can access only the floor corresponding to the dwelling that has opened the door. It is an interface between DUOX PLUS and MDS, the MDS Central Unit being in charge of the elevator control functionality, together with the relay decoders.

It is connected to the DUOX PLUS bus, the MDS Panel bus and the MDS Decoders bus.

• The elevator control functionality must be programmed in the Central Unit

MDS, with WINCOM+ software. Available at www.fermax.com in ONLINE SUPPORT/

SOFTWARE along with manuals.

• An elevator control module ref. 9443 and a central MDS ref. 2405 for each DUOX PLUS block.

• DUOX PLUS general entrance panels are considered as MDS panel with address 10, regardless of whether there is more than one. The rest of the MDS addresses [11...31] are reserved for MDS equipment: panels, access control readers or door controllers.

System: DUOX PLUS (2 digital wires)

Technical specifications

The assembly can be done both by screw fixing, and by installation on a DIN rail. Dimensions: 86 (H) x 89 (V) x 26 (D) mm. // 3.38(H) x 3.50(V) x 1.02(D) inches.

Supply voltage: 18 - 24 Vdc (obtained from the DUOX bus); 12 Vdc (uses power from MDS)

Standby consumption: 0.5 W

Maximum consumption: 0.54W

Operating temperature: -5 ºC to +40 ºC // 23 ºF to 104 ºF

Humidity: 90% non-condensing