Optex AXPRO-VXI-R Dual dual PIR detector for outdoor side view

Optex AXPRO-VXI-R. Dual dual PIR detector for outdoor side view. Coverage of 12m on each side. It can be connected to a CCTV camera for sending visual alarms. Advanced processing logic SMDA. 4 detection zones (2 on each side). Detection range adjustable in 5 levels. Adjustable sensitivity in 3 levels. Independent alarm outputs on each side, fault / tamper output and tamper against tampering. Double conductive mesh (patented) to avoid interference. IP55. Self-powered with lithium or alkaline batteries 3V ~ 9V DC or from transmitter via radio. Hik-327 + optex-18.

Features

- Double PIR dual side view detector for outdoor

- Side view with dual sensor on each side

- Can be connected to a CCTV camera to send a visual alarm when an intruder is detected

- 4 PIR technology: the detection range, the sensitivity and the alarm output can be configured independently on each side

- Coverage of 12 meters on each side

- Angle to the wall adjustable to 0 ° or 3 °

- 2 detection zones on each side

- Detection range adjustable in 5 levels (2,5 / 3,5 / 6 / 8,5 / 12 meters)

- Mounting height of 0.8 ~ 1.2 meters

- Adjustable sensitivity on each side (extremely high and normal)

- SMDA processing logic (Super Multi-Dimension Analysis) against false alarms due to vegetation and adverse climatic factors

- Quick closing of the front cover, pressure, and walk test (3 minutes duration) automatic closing the lid

- Alarm relay right side: NC / NA (10V DC, 0.01A, idividual, right or general)

- Alarm relay left side: NC / NA (10V DC, 0.01A, idividual, left or general)

- Fault output / tamper: NC / NA (10V DC, 0.01A)

- Built-in rear tamper

- Double conductive mesh protection

- Built-in level for fast and accurate installation

- Easy visual identification of all adjustment elements (marked in blue on the detector)

- Quick opening by turning 90 degrees in lower screw

- Includes a protected passenger compartment on the back to house the transmitter via radio

- Degree of protection IP55

- Operating temperature of -30 ° C ~ + 60 ° C

- Powered by lithium or alkaline batteries of 3V ~ 9V DC (not included)

- Compatible batteries: CR123A x3, 1 / 2AA x3 or x6, CR2 x3

- Battery compartment: OPTEX-42 (RBB-01)

- It is recommended to power from the transmitter battery via radio 

- Maximum consumption: 8mA

- Dimensions: 199.7 x 92.8 x 98.7 mm